|
|
REVIEW ARTICLE |
|
Year : 2006 | Volume
: 6
| Issue : 4 | Page : 170-174 |
|
Cast partial denture: Laboratory step by step
K.S.G.A Nasser
Department of Prosthodontics, Tamil Nadu Government Dental College and Hospital, Chennai, India
Correspondence Address: K.S.G.A Nasser 153, Secretariat Colony, Kellys, Chennai - 600 010 India
 Source of Support: None, Conflict of Interest: None  | Check |
DOI: 10.4103/0972-4052.30690
Fabrication of a cast partial denture is a difficult process and every one does it a different way and in order to give a correct method, I have divided in to steps and given a pictorial method to make every one to understand the exact method of production of cast partial denture. It is an important process for every prosthodontist. Keywords: Chrome cobalt solder, gold solder, surveyer
How to cite this article: Nasser K. Cast partial denture: Laboratory step by step. J Indian Prosthodont Soc 2006;6:170-4 |
 | Step 1: Production of master model, surveying, blocking out, and duplicating
Click here to view |
 | Step 1: Production of master model, surveying, blocking out, and duplicating
Click here to view | Every prosthodontist knows about cast partial denture and they are aware of theory but practically the exact procedure of making a cast partial denture is different. In first person here the exact procedure is formulated and presented as a working catalogue.
The exact procedure is divided into five steps, four belonging to the metal frame work and the fifth one is the regular acrylic work.
- Production of master model, surveying, blocking out, and duplicating
- Production of duplicate model, hardening and modeling
- Investing, preheating, and casting
- Deflasking, blasting, finishing, polishing, and soldering
- Preparing the metal frame work for acrylic work.
Since the procedure needs an extensive picturing I have inducted few pictures
Step 1 to step 4 in tabulated format.
Step 5. Preparation of the metal framework for acrylic
This procedure is the regular procedure of articulation, arrangement of all the remaining teeth, wax up and finishing the acrylic framework in the usual way.
Conclusion | |  |
A step-by-step procedure of making a metal framework has been dealt in detail with the exact procedure, type of work done, materials and the Equipments needed for every step has been included. This can be used as a step-by-step manual.
[Figure - 1], [Figure - 2], [Figure - 3], [Figure - 4], [Figure - 5], [Figure - 6], [Figure - 7]
[Table - 1], [Table - 2], [Table - 3], [Table - 4]
|